– It has a fully automatic sorting and sorting system
– It has bars for carrying goods to sort and create a suitable distance between the products exited from the gate
– It has a diecut chain in order to place the product inside the diecut sole and close the edges of the carton
– With nylon carrier rods to perform the operation of wrapping the plastic around the product (overlapping operation)
– It has a nylon carrier conveyor belt to guide the nylon under the product
– With PVC conveyor belts in the overlap part to transfer the plasticized product into the thermal tunnel
– It has an automatic box cutter using a special steel cutter blade (HSS) and rubber hubs
– It has a pneumatic roll opener system in order to create the necessary reserve for nylon tension
– It has a nylon storage roll system to reduce stops caused by changing the roll along with a sewing system with pneumatic actuators.
– With automatic and manual synchronizer system
– It has a mechanical protection system for separating and carrying goods and nablon rods
– It has a spiral air circulation system to even out the air temperature inside the tunnel
– Having the adjustment of hot air blowers inside the tunnel
– With cooling fans to increase the strength of the packaging
-Having single wing chain can conveyor belt using steel chain
– With a double fireproof silicone curtain to prevent energy loss at the beginning and end of the tunnel
– It has preheat and postheat at the beginning and end of the tunnel in order to prevent energy loss
– With 4 inches of stone wool and glass insulation
– With the ability to quickly replace the thermal elements from outside the tunnel
– It has a pneumatic control panel with pneumatic accessories including control and care unit, manifold, electric valves, flow controls
– It has a 40 cm long end roller table to stop goods on it
Ease of placing and replacing the film roll and embedding the storage roll location
– Complete piping inside the tunnel for the passage of wires and cables
– The ability to move the device with a rotating wheel and install it with fixed bases in a specific position
– It has a steel furnace made of 309 refractory sheet
– Has Iran radiator RAN25 gas torch
– The ability to automatically adjust the temperature of the tunnel as PID control with a tolerance of about 2 to 3 degrees Celsius only in the electrical operation mode of the device
– High safety and protection to prevent burning of motors and electrical appliances in case of problems
– Set device parameters graphically through the HMI display
– Setting the frequency of all motor drives of the device through the HMI display
– Adjusting and monitoring the temperature inside the tunnel through the HMI display
-Monitoring all inputs and outputs of the device
– Tunnel temperature monitoring on the display through the PLC module
– It has a quick protection system in case of any problem in the automatic operation of the device (the package gets stuck in the bars of the device, etc.)
– It has an automatic synchronizer system with the fastest possible time through PLC
– It has a transformer that reduces the sewing part of the storage roll for more safety
– With electronic sensors for automation applications
– It has a power regulator system using a three-phase SSR to increase the life of the device’s thermal elements and reduce the thermal tolerance of the tunnel, as well as reducing electricity consumption by up to 50% only in the electric mode of the thermal tunnel.
– It has an electricity arrester system on the box cutter of the device in order to reduce the effects of static electricity
– With stepper motor cutter system
– It has a motorized stepper floor magazine system