– It has a spiral wind deflector system to circulate and even out the air in the tunnel
– The presence of initial heat and later at the beginning and end of the tunnel
– Insulation of three layers of glass wool, stone wool and air in the walls and roof of the tunnel
– Complete piping and channeling of the tunnel for the passage of wires, cables and pneumatic hoses
-Adjustment of hot air dampers inside the tunnel around the product (walls and top)
– Special stainless steel stove with a separate gas burner
-Initial and final conveyors in the form of double-wing chain cans reinforced against impacts caused by forklift loading, each 170 cm long and 120 cm wide.
-Tunnel conveyor in the form of a can and chain with two reinforced wings to support weights up to 2500 kg with a length of 500 cm
– Opening and closing the machine doors pneumatically in order to prevent damage to the machine and the pallet before and after shringing.
– It has a separate pneumatic box with relevant accessories, including care and lubrication and filtration units, electric valves, flow controls
– It has three separate motors and gearboxes for each of the initial, tunnel and end conveyors as an indirect coupling.
– With rails holding the return conveyor under the machine
– The presence of initial heat and later at the beginning and end of the tunnel
– Insulation of three layers of glass wool, stone wool and air in the walls and roof of the tunnel
– Complete piping and channeling of the tunnel for the passage of wires, cables and pneumatic hoses
-Adjustment of hot air dampers inside the tunnel around the product (walls and top)
– Special stainless steel stove with a separate gas burner
-Initial and final conveyors in the form of double-wing chain cans reinforced against impacts caused by forklift loading, each 170 cm long and 120 cm wide.
-Tunnel conveyor in the form of a can and chain with two reinforced wings to support weights up to 2500 kg with a length of 500 cm
– Opening and closing the machine doors pneumatically in order to prevent damage to the machine and the pallet before and after shringing.
– It has a separate pneumatic box with relevant accessories, including care and lubrication and filtration units, electric valves, flow controls
– It has three separate motors and gearboxes for each of the initial, tunnel and end conveyors as an indirect coupling.
– With rails holding the return conveyor under the machine
-Separate electrical panel with electrical accessories
-Has a PLC controller
– Wires and cables of coated type
– The ability to automatically adjust the temperature of the tunnel through the thermostat
– Be sure to protect your motor and cable accessories if a problem arises
-Magnetic sensors to protect the device doors
– The end sensor to protect the pallet at the output of the machine
– Primary sensor to protect the pallet and doors at the entrance of the machine
-Has a PLC controller
– Wires and cables of coated type
– The ability to automatically adjust the temperature of the tunnel through the thermostat
– Be sure to protect your motor and cable accessories if a problem arises
-Magnetic sensors to protect the device doors
– The end sensor to protect the pallet at the output of the machine
– Primary sensor to protect the pallet and doors at the entrance of the machine
.